Panasonic KX-FC962HK - Manual (Page 60)

8. Answering Machine
60
mode depending on the setting of feature #73
(page 65).
L You cannot return to TAM/FAX mode in the
same call.
To turn ON the auto answer setting
1. Call your unit and wait for 15 rings.
L A beep will sound.
2. Enter the remote operation ID (feature #11 on
page 62) within 8 seconds.
L The auto answer setting will be turned
ON. The receiving mode will be set to
TAM/FAX or FAX ONLY mode, depending
on the setting of feature #77 (page 65).
3. Hang up the handset.
Note:
L You cannot turn ON the auto answer setting
in the following cases:
–
when the unit is set to TEL/FAX mode.
– when the unit is set to TEL mode and
night mode (feature #35 on page 33) is
turned ON.
Recording a marker message
After playing back the messages, you can leave
an additional message.
1. Wait about 10 seconds.
2. Leave a message after the beep.
Note:
L If you do not enter a remote command key
within 10 seconds after the last operation, the
unit will ask you to leave a marker message.
8.5 Pager call
This feature allows your unit to call your pager
when your unit receives an incoming voice
message.
1 Press {MENU}.
2 Press {#}, then {7}{0}.
3 Press {A} or {B} repeatedly to select “ ON”.
4 Press {SET}.
5 Enter your pager number and/or pauses (up
to 46 digits).
Example:
1 202 555 1234PP12345678PP5555#
–
1 202 555 1234: Your pager number
– PP: Pauses
– 12345678: Your pager access code, if
required.
– 5555 (example): Message you want
displayed on your pager.
6 Press {SET}.
L The unit will dial the stored number.
7 Check that your pager received the pager
test call.
8 Press {SP-PHONE}, or wait for 10 seconds.
When your pager receives a pager call
Your pager will display the message you entered
in step 5 (for example:5555).
{ SP-PHONE}
{A}{B}
{ SET}
{ MENU}
FC962HK-PFQX2283ZA-en.book Page 60 Thursday, September 15, 2005 4:20 PM