Panasonic KX-FC962HK - Manual (Page 75)

10. Multi-unit Operation
75
10 Multi-unit Operation Additional Units
10.1 Operating additional
units
10.1.1 Additional cordless
handsets
Up to 6 cordless handsets can be registered to a
single base unit. Additional cordless handsets,
for example, will allow you to have an intercom
call with another cordless handset while the third
cordless handset is on an outside call. See page
5 for accessory information.
10.1.2 Additional base units
Cordless handsets can be registered to up to 4
base units, allowing you to add additional base
units and extend the area in which your cordless
handset(s) can be used. If a cordless handset
moves out of range of its base unit when “
Auto”
is selected on base unit selection (page 76), it
will look for another base unit to make or receive
calls. Each base unit forms 1 radio cell.
Note:
L Calls will be disconnected when the cordless
handset moves from one radio cell to
another.
L Intercom calls and call transfers are only
possible between cordless handsets in the
same radio cell.
10.2 Registering a
cordless handset to a base
unit
The included cordless handset and base unit are
preregistered. After purchasing an additional
cordless handset, register it to the base unit.
Ensure that the additional cordless handset is
switched ON. If it is not ON, press and hold
{ih}
for few seconds to turn the cordless
handset ON.
1 Press {j/OK}.
2 Select “ Handset Setup”, then press {>}.
3 Select “ Registration”, then press {>} 2
times.
4 Press and hold {INTERCOM} on the base
unit for about 3 seconds, until the registration
tone sounds.
L If “ INTERNAL CALL” is displayed, press
{ INTERCOM}, then repeat this step.
L After pressing {INTERCOM}, the rest of
this procedure must be completed within
1 minute.
5 Select a base unit number, then press {>}.
L This number is used by the cordless
handset as a reference only.
{ INTERCOM}
{ih}
{>}
{j /OK}
FC962HK-PFQX2283ZA-en.book Page 75 Thursday, September 15, 2005 4:20 PM