Panasonic KX-FC962HK - Manual (Page 64)

9. Programmable Features
64
See page 52 for details.
Code #35: Setting the night mode
NIGHT MODE
PRESS SET
See page 33 for details.
Code #36: Receiving oversized documents
RCV REDUCTION
=ON [±]
To slightly reduce the received fax image when
printing, so that the received document will be
approximately the same length as the original
document.
“
ON” (default): The received fax image will be
printed slightly smaller than the original image.
“
OFF”: Deactivates this feature. The received
fax image will be printed at the same size as the
original image.
Note:
L An slight margin will be added to the printed
documents, and therefore if this feature is
turned OFF, the received document will be
slightly longer than the original document.
Code #39: Changing the display contrast
LCD CONTRAST
=NORMAL [±]
“ NORMAL” (default): For normal contrast.
“ DARKER”: Used when the display contrast is too
light.
Code #41: Changing the fax activation code
FAX ACTIVATION
=ON [±]
If you wish to use the cordless handset (page 47)
or an extension telephone (page 47) to receive
faxes, activate this feature and program the
activation code.
1. Press {MENU}.
2. Press {#}, then {4}{1}.
3. Press {A} or {B} repeatedly to select “ ON”.
4. Press {SET}.
5. Enter your code (2 to 4 digits) using the dial
keys {0}–{9}, {*} and {#}.
L The default code is “@@@ 9”.
L Do not enter “0000”.
L This activation code will be required when
receiving faxes using an extension
telephone (page 47).
6. Press {SET}.
7. Press {MENU}.
Code #42: Setting the message alert
MESSAGE ALERT
=OFF [±]
To alert you when a new voice message is
recorded. The unit beeps slowly until you listen
to the recorded messages.
“
ON”: You will be alerted to new messages by a
beeping sound.
“
OFF” (default): Deactivates this feature.
Code #44: Setting the memory reception alert
RECEIVE ALERT
=ON [±]
To alert you with a beeping sound when a
received fax document is stored into memory
due to some existing problem.
The slow beeps will continue until you clear the
printing problem and make sure the unit is
supplied with enough paper to print the stored
document.
“
ON” (default): You will be alerted to a reception
problem by a beeping sound.
“
OFF”: Deactivates this feature.
Code #46: Setting friendly reception
FRIENDLY RCV
=ON [±]
To receive a fax automatically when you answer
a call and hear a fax calling tone (slow beep).
“
ON” (default): You do not have to press
{ FAX/START} for fax reception.
“ OFF”: You have to press {FAX/START} for fax
reception.
Code #49: Setting the auto disconnection
AUTO DISCONNECT
=ON [±]
To answer a call with an extension telephone in
TAM/FAX mode (page 50) and TEL/FAX mode
(page 48), activate this feature and program the
code.
1. Press {MENU}.
2. Press {#}, then {4}{9}.
3. Press {A} or {B} repeatedly to select “ ON”.
4. Press {SET}.
5. Enter your code (2–4 digits) using the dial
keys {0}–{9} and {*}.
L The default code is “@ 0”.
6. Press {SET}.
7. Press {MENU}.
FC962HK-PFQX2283ZA-en.book Page 64 Thursday, September 15, 2005 4:20 PM