Panasonic KX-FT21HK - Manual (Page 17)

17
Setup
Initial
Preparation
Recording paper !
Document stacker !
1 Open the cover by pressing the cover open
button and install the recording paper roll.
● If the paper is secured with glue or tape,
cut approximately 15 cm (6 inches) from
the beginning.
2 Pull the leading edge of the paper
approximately 10 cm (4 inches) out of the
unit.
● Make sure that there is no slack in the
paper roll.
3 Close the cover securely by pushing down
on both ends.
4 Tear off the excess paper by pulling it
towards you.
Install the document stacker.
Cover open
button
10 cm
Document stacker
Note:
● Only use the included roll of paper or specified recording paper, or else the print quality may be
affected and/or excessive thermal head wear may occur.
● For accessory order information, see page 12.
● When the power cord is connected, everytime you close the cover a message will be printed. If the
recording paper is set to the wrong side, the message will not be printed. Install the paper correctly.
correct incorrect