Paradyne Hotwire ATM Line Cards 8385 - Manual (Page 117)

8335-A2-GB20-70 February 2003 B-1
B
SNMP Traps
Trap Managers
SNMP traps are sent to trap managers whose addresses are entered on the
SNMP Communities/Traps configuration screen of the MCP. See the
Hotwire
Management Communications Controller (MCC) Card, IP Conservative, User’s
Guide
for information about management domain configuration.
SNMP Traps
Traps are configured via a Telnet or terminal session. See the Hotwire
Management Communications Controller (MCC) Card, IP Conservative, User’s
Guide
for information about enabling and routing traps.
Table B-1, SNMP Traps , shows the traps supported on the Hotwire ATM Line
Cards.
Table B-1. SNMP Traps (1 of 6)
Event Description Variable Bindings
Cold start(0) Card has been reset and performed a
cold start. None
Warm start(1) Power on reset.
LinkDown(2) One of the communication interfaces has
failed. ifIndex (RFC 2863)
ifAdminStatus (RFC 2863)
ifOperStatus (RFC 2863)
LinkUp(3) One of the communication interfaces has
come up.
adslAtucPerfLofsThreshTrap Loss of Framing 15-minute interval
threshold reached. ifIndex (RFC 2863)
adslAturPerfCurr15MinLofs
adslAturThresh15MinLofs
adslAtucPerfLossThreshTrap Loss of Signal 15-minute interval
threshold reached. ifIndex (RFC 2863)
adslAtucPerfCurr15MinLoss
adslAtucThresh15MinLoss