Paradyne Hotwire ATM Line Cards 8385 User Manual
Page 121
B. SNMP Traps
8335-A2-GB20-70
February 2003
B-5
hdsl2ShdslpowerBackoff
The bit setting for power backoff for this
endpoint has changed.
IfIndex
hdsl2ShdslInvIndex
hdsl2ShdslEndpointSide
hdsl2ShdslEndpointWirePair
hdsl2ShdslEndpointCurrStatus
hdsl2ShdsldcContinuityFault
The bit setting for the DC continuity fault
for this endpoint has changed.
hdsl2ShdslconfigInitFailure
The bit setting for the config init failure for
this endpoint has changed.
hdsl2ShdslprotocolInitFailure
The bit setting for the protocol init failure
for this endpoint has changed.
hdsl2ShdslnoNeighborPresent
The bit setting for no neighbor present for
this endpoint has changed.
hdsl2ShdsllocalPowerLoss
Impending unit failure due to loss of local
power (last gasp).
IfIndex
hdsl2ShdslInvIndex
mpeSelfTestFailure
Hardware failure detected during selftest.
entPhysicalIndex
mpedevSelfTestResults
mpeDevFileXferEvent
Contains information about a file transfer.
mpeDevFileXferName
mpeDevFileXferType
mpeDevFileXferOperation
mpeDevFileXferErrorStatus
mpeDevFileXferStatus
pdnAtmIfConfExtExcessInvalid
CellsAlarm
The number of cells with uncorrectable
HEC errors has exceeded the
user-defined threshold.
IfIndex
pdnAtmIfConfExtUnknownCell
Threshold
IfOperStatus
pdnAtmIfConfExtLineRateAlarm
Set
Line rate dropped below a value which
violates traffic contracts of connections.
IfIndex
pdnAtmIfConfExtLineRateAlarm
Clear
Line rate has risen above a value which
would no longer violate traffic contracts of
connections.
IfIndex
pdnAtmIfConfExtVclNoBandwidth
Avail
Traffic contracts associated with the VC
cross connect cannot be satisfied by the
ATM switch.
AtmVcCrossConnectIndex
AtmVcCrossConnectLowIfIndex
AtmVcCrossConnectLowVpi
AtmVcCrossConnectLowVci
AtmVcCrossConnectHighIfIndex
AtmVcCrossConnectHighVpi
AtmVcCrossConnectHighVci
pdnAtmIfConfExtLineRateAlarm
Set
Configuration has changed so that the
previously valid CAC contracts can no
longer be guaranteed in the egress
direction.
IfIndex
Table B-1.
SNMP Traps (5 of 6)
Event
Description
Variable Bindings