Document Outline

• WHAT IS A GENESIS SERIES BRUSHLESS DC DRIVE ?
  • ABSOLUTE SPEED CONTROL
  • HIGH EFFICIENCY
  • LOW MAINTENANCE
  • SPECIFICATIONS
    • Environmental
    • Dimensions
    • Performance
    • Adjustments
    • Jumpers See Page 32
    • LED Indicators See Page 36
    • Terminal Assignments See Page 22
• REGENERATIVE VERSUS NON-REGENERATIVE OPERATION
  • MODEL 1000AR STANDARD CONNECTIONS
  • CONNECTIONS
  • START UP
  • REFERENCE PAGES
  • INSTALLATION
    • How Do I …
  • START UP
    • What Happens When I …
  • TROUBLESHOOTING
    • Troubleshooting Chart
  • MOTOR PROTECTION CONSIDERATIONS
  • SUMMARY OF WARRANTY AND DISCLAIMER
  • M
  • MODEL 1000AR DIMENSIONS
    • • CHASSIS UNITS
      • ENCLOSED UNITS
  • HOW DO I …
    • • PHYSICALLY INSTALL THE MODEL 1000AR DRIVE?
  • MODEL 1000AR AC INPUT ELECTRICAL RATINGS
    • • • Notes
  • HOW DO I …
    • • CONNECT AC POWER TO THE 1000AR DRIVE?
      • MODEL 1000AR FUSE BOARD
    • Model 1000AR Output Electrical Ratings
  • HOW DO I …
    • • CONNECT THE MOTOR TO THE 1000AR DRIVE?
• REGENERATIVE RESISTORS
  • HOW DO I …
    • • CONNECT THE REGENERATIVE RESISTORS TO THE MODEL 1000AR?
  • CONTACTOR SPECIFICATIONS
  • DYNAMIC BRAKING RESISTORS
  • HOW DO I …
    • • CONNECT AN OUTPUT CONTACTOR?
  • HOW DO I …
    • • CONNECT DYNAMIC BRAKING?
  • MODEL 1000AR CONTROL CONNECTIONS
    • • CONNECT STANDARD CONTROL CIRCUITS?
        • The motor thermal must be used to PROPERLY protect the motor!
  • TERMINAL DESCRIPTIONS - MODEL 1000AR
    • TB1 Current Controller Board (141-108)
    • TB2 Speed Controller Board (147-101)
    • TB3 Capacitor Board (141-106)
    • TB5 Bus Loader (Integral unit connected to Driver board)
  • HOW DO I …
    • • GET RUN, ZERO SPEED, FAULT AND ENABLE INFORMATION?
  • PLC INTERFACE
  • HOW DO I …
    • • CONNECT AN ANALOG SPEED REFERENCE?
  • DIGITAL MODE NOTES
  • HOW DO I …
    • • CONNECT A DIGITAL SPEED REFERENCE?
  • ANALOG VERSUS DIGITAL OPERATION
  • HOW DO I …
    • • CONNECT A DIGIMAX®?
  • INSTALLATION CHECKLIST
  • WHAT HAPPENS WHEN I …
    • • APPLY POWER TO THE MODEL 1000AR ?
  • JUMPERS
  • WHAT HAPPENS WHEN I …
    • • GIVE THE START COMMAND TO THE MODEL 1000 ?
  • LED INDICATORS
  • WHAT HAPPENS WHEN I …
    • • GIVE THE SPEED COMMAND TO THE MODEL 1000AR ?
  • LED INDICATORS
  • WHAT HAPPENS WHEN I …
    • • SLOW DOWN OR OVERHAUL THE MODEL 1000AR ?
  • ADJUSTMENTS
  • WHAT HAPPENS WHEN I …
    • • MAKE AN ADJUSTMENT ON THE MODEL 1000AR ?
• TROUBLESHOOTING THE MODEL 1000AR DRIVE
  • TRANSISTOR MODULE STATIC TEST
  • DIODE BRIDGE TEST
  • TRANSISTOR LEAKAGE TEST
  • IOC TESTS:
  • OV/UV TESTS:
• BLOCK DIAGRAM - - SPEED CONTROLLER AND CURRENT CONTROLLER
• DRIVER BOARD LAYOUT AND CONNECTIONS
• DRIVER BOARD LED’S
• 1000rgimcvr.pdf
  • Model
    • Regenerative
    • Brushless DC Motor Control
      • Installation and
        • Operation
      • Instruction Manual