Panasonic WV-NS324 - Manual (Page 13)

-13-
• Ethernet Connection
q
Red
Data transmission
Data reception
Orange
Yellow
Green
w
e
r
t
y
u
i
TX +
RX +
RX –
TX –
• ALARM IN Connections
An 8-pin and a 4-pin harness are supplied with the
camera as standard accessories. Connect external
sensors to this connector. Input specifications are
low-active, non-voltage contact (ON when active)
or open collector (Low when active). The table
below shows wire colors versus pin functions.
• ALARM OUT/AUX OUT Connections
Connect an external device, for example, a buzzer
or lamp, to this connector. Output specifications
are low-active, open-collector and a drive capacity
of 16 V DC 100 mA maximum. The table below
shows wire colors versus pin functions.
Note: Use a relay if the voltage or current of the
connected device exceeds the ratings.
• Video Cable Connections
The maximum extensible coaxial cable length
between the camera and the monitor is shown in
the table.
Network Connections
Prior to connections, specify the connection type and
prepare relevant devices and cables.
Notes:
• We recommend that you use connection type 1 or
2 when setting up the network address of the cam-
era.
• Be sure to unplug or switch off all the devices
before starting connections.
• Direct Connection to PC (Type 1)
Use a category 5 cross-type network cable to connect
the camera directly with the PC.
Necessaries: Cross-type network cable (Category 5)
IN 1
GND
IN 2
GND
GND
GND
GND
GND
Black
Brown
Red
Orange
Yellow
Light Blue or Green
Blue
Purple
Wire Color Function
Alarm IN (8-pin)
Wire Color
Gray
White
Pink
Yellow Green or Light Blue
Function
Alarm OUT
GND
AUX OUT
GND
Alarm OUT/AUX OUT (4-pin)
Type of RG-59/U RG-6/U RG-11/U RG-15/U
coaxial cable (3C-2V) (5C-2V) (7C-2V) (10C-2V)
Recommended (m) 250 500 600 800
maximum
cable length
(ft) 825 1 650 1 980 2 640
Network Cable (Cross type)
PC