Initializing, Setting the switches, Common procedures – Panasonic WV-NS324 User Manual
Page 51
You can reset the following data to the factory default
settings.
Camera Setup
HTML files
Setting the Switches
The camera is provided with an 8-bit DIP switch. The 8-
bit DIP switch is used to return the camera to the facto-
ry default settings. Switch settings are read into the
camera when the power is turned on. Make sure to turn
the camera off, then turn it back on after changing the
switch settings. Switch positions and functions are
shown below.
Note:
All DIP switches except SW1 and SW2 should
always be set to "off".
Menus:
Initializing Setup menu
Initializing HTML files
Initializing Setup menu and HTML files
Common procedures:
1. Set DIP SW1 and SW2 in accordance with the
table.
2. Turn the power on, and wait until the servo initial-
ization of Camera is completed.
3. Turn the power off, and return the DIP switch to
normal position.
Note:
Do not make any DIP switch setting other than
above.
No.
Dip SW
Position
DIP
SW1
DIP
SW2
Status
1 OFF OFF Normal
1
2
3
4
ON
5
6
7
8
8-bit DIP SW
Normal Position
1
2
3
4
ON
5
6
7
8
1
2
3
4
ON
5
6
7
8
1
2
3
4
ON
5
6
7
8
2
ON
OFF Initializing the setup menu
3 OFF
ON
Initializing HTML files
4
ON ON
Initializing the setup menu
& HTML files
-52-
INITIALIZING