Panasonic WV-NS324 - Manual (Page 47)

-48-
1. Click the [FTP Client] button.
2. Common Setup
• Enter the FTP server address.
A hostname.domainname can be entered
when using the DNS function.
• Enter the user name in a maximum of 16 char-
acters.
• Enter user name and password in a maximum
of 16 characters to access the FTP server.
• Select Sequential or Passive as the transmis-
sion mode. Passive is recommended when
Sequential does not perform properly.
• Complete schedule 1 and 2 by specifying the
transmission time zone and the day of the
week.
3. Non-Alarm (FTP) Image Transmission Setup
• Select ON or OFF to transmit ordinary image
files except in an alarm condition.
ON: Transmits files when a scheduled time
comes.
OFF: Does not transmit, and no schedule is
applied.
• Enter the receiver directory.
• Enter the file name and click FIX or DATE.
FIX: Uses repeatedly a single file name when
overwriting new data.
DATE: Creates and attaches a serial number
and a date-and-time to the entered file
name.
• Select the transmission interval by pressing
the [o] button.
Available times (seconds): 0.2 - 0.9, 1 - 1
440
Available times (minutes): 1 - 1 440
Notes:
• The transmission may be longer due to the
network speed and/or traffic conditions.
• An alarm image precedes a non-alarm image
in transmission to the FTP server. The non-
alarm image may not be sent when alarm acti-
vations frequently arise.
4. Alarm (FTP) Image Transmission Setup
The alarm setup window specifies the profile of the
file transmission such as the number of files and
the frame rate (fps).
• Select ON or OFF to transmit the image files.
ON: Transmits the files when alarm arises.
OFF: Does not transmit.
• Enter the receiver directory.
• Enter the file name.
5. Click the [SET & REBOOT] button.
Note: Wait around 5 seconds or more when exe-
cuting [SET&REBOOT] button.
6. Click the [Go to Main Menu] button to go back to
the main window.
Note: Set the file system on the FTP server to the
UNIX mode when using the FTP client function.
■ User Setup
1. Open the User Setup window.
2. User Registration
• Enter the user name in up to 16 characters.
The default setting is "admin". Only one admin-
istrator is necessary.
• Enter the password. The default setting is a
blank.
• Enter a password again.
• Select an access level, and click the [SET]
button.
1 (Administrator): Allows you to operate
setup menus and to view live and record-
ed images.
2 (Camera Control): Allows you to control
camera functions and to view live and
recorded images.
3 (Live Only): Allows you to view live and
recorded images.
3. User Authentication
• Select ON or OFF, and click the [SET] button.
ON: applies the user authentication.
OFF: does not apply.
• Click the [DEL] button after selecting an
unwanted user name to cancel it.
Note: The registered defaults admin and level
1 cannot be changed while password
entry is enabled.
4. Delete User
• Click the [DEL] button after selecting the user
name to be deleted if necessary.
Note: The registered defaults admin and level
1 cannot be changed while password
entry is enabled.
Be sure to first set the admin password.
No default password is registered.
• All users will become level 3 if both the host
and the user authentications are set to OFF.