Panasonic TQBH9003-6 - Manual (Page 100)

100
If wireless communication has already been
established between PCs (in ad hoc mode)
In this case, it is required to make settings so that direct wireless communication will
be available between the personal computers and the projector in ad hoc mode using
the wireless cards that are currently used in the PCs.
For details of setting the projector, refer to "Setting the projector" on page
104 .
R
Personal computer Personal computer Projector
Typical setting
Setting of the projector Parameters
IP address Assign an IP address that is different from that of PC.
Example: If the IP address of the PC is 192.168.10.11, assign
an address such as 192.168.10.12 to the projector.
Subnet mask
Mode
Channel
Use the same settings as the PC.
AD HOC
Use the same setting as the PC.
Notes:
• The settings of the PC are available without modification. However, give the same
WEP settings to the projector as the PC because the projector will also support
WEP if the WEP function is enabled on the PC.
If the WEP function is disabled, data encryption is also disabled. Therefore, it is
recommended to take measures for data protection such as setting a password in
folder sharing. For details, please consult your network administrator.
• Compatibility with other cards than the optional wireless card (ET-CDWL1) is not
guaranteed.