Panasonic TQBH9003-6 - Manual (Page 106)

106
KEY SIZE (encryption key size)
Set the size of the key required for the encrypted communication.
Conform to the setting of the personal computer and the access point. In some
cases, 64 bits may be indicated as 40 bits and 128 bits as 104 bits.
Use
and buttons to toggle the values and press the ENTER button
when the setting is completed.
KEY ID (encryption key ID)
Specify the ID of the encryption key to be used.
Conform to the setting of the personal computer and the access point.
Use
and buttons to select values and press the ENTER button when
the setting is completed.
KEY (encryption)
Enter a 10-digit key for 64-bit and a 20-digit key for 128-bit using characters 0 to 9
and A to F.
Conform to the setting of the personal computer and the access point.
Use
and buttons to select the value, use the and buttons to
switch the digit and press the ENTER button when the setting is completed.
Mounting a projector LAN card
For the setting of the projector when mounting a projector LAN card, refer to
“Mounting a wireless card” on page 104.
In the LAN setup wizard of “Status”, however, only set the IP address, Subnet mask,
Gateway and Host name.
Further, no “WEP” setting is provided there.
WEP setup wizard