67 others – Panasonic TQBH9003-6 User Manual

Page 67

Advertising

Others

+ Press the ENTER button and

select the “LAMP RUN TIME” by
pressing the F or G buttons.

, Press and hold the ENTER

button for approximately 3
seconds.

The “Lamp Time Reset” will be
displayed.

- Select “OK” by pressing the

I or H

H buttons and press the

ENTER button.

NOTE:
B If “CANCEL” is selected in step

-, the operation for resetting the
lamp time will be cancelled.

. Turn off the power.

This will reset the cumulative
usage time for the lamp unit to
zero.
Refer to steps % and & on page

for details on how to turn off

the power.

' Close the air outlet port, and

then use a Phillips screwdriver
to securely tighten the air
outlet port fixing screws.

NOTE:
B Be sure to install the lamp unit

and the air outlet port securely. If
they are not securely installed, it
may cause the protection circuit
to operate so that the power
cannot be turned on.

( Insert the power cord plug into

the wall outlet and then press
the MAIN POWER switch.

NOTE:
B If the POWER indicator on the

projector does not illuminate red
when the MAIN POWER switch is
turned on, turn the MAIN POWER
switch off again and check that
the lamp unit and the air outlet
port are securely installed. Then
turn the MAIN POWER switch
back on.

) Press the POWER button so

that a picture is projected onto
the screen.

* Press the MENU button to

display the MENU screen, and
select “OPTION” by pressing
the I

I or H

H buttons.

OPTION

SHUTTER

OSD

AUTO KEYSTONE

RGB/YPbPr

RGB2 SELECT

BACK COLOR

FRONT/REAR

DESK/CEILING

LAMP POWER

LAMP RUN TIME

NEXT PAGE @

1820 H

OFF

RGB

INPUT

BLUE

FRONT

DESK

LOW

YPbPr

OUTPUT

BLACK

REAR

CEILING

HIGH

SELECT:[{][}]

ADJUST:[{][}]

ENTER:[ENTER]

ESC:[MENU]