Panasonic TQBH9003-6 - Manual (Page 105)

105
Gateway
This is a relaying point to connect two networks. It does not work in ad hoc mode.
This address must be specified when connecting to a network of a different
segment in infrastructure mode or peer-to-pee mode or to connect to the Internet.
For the details of specification of address, consult your network administrator.
Host name
Set the name of the projector on the network.
The name must be up to 16 alphanumeric characters and symbols.
Use
and buttons to change the value, and use and buttons to
switch the characters to be changed.
Press the ENTER button when the setting is completed.
Mode
Make setting for the modes of “AD HOC”, “INFRASTRUCTURE” and “PPEER-TO-
PEER”.
Specify “AD HOC” when “To use wireless communication for the first time” or when
“If wireless communication has already been established between PCs (in ad hoc
mode)”. Specify “INFRASTRUCTURE” when “If wireless communication has
already been established using an access point”. Specify “PEER-TO-PEER” when
“If communication in ad hoc mode is unavailable”.
Press the ENTER button when the setting is completed.
SSID (in INFRASTRUCTURE mode or in PEER TO PEER mode
only)
Change the setting to the same name as the “SSID” that is set for the access point
for communication in infrastructure mode or peer-to-peer mode.
• For the SSID of the projector, up to 32 alphanumeric characters and symbols are
available. For this reason, if the SSID of the access point cannot be used in the
projector, consult the network administrator and have the SSID changed to the
one that can be used in the projector.
Use and buttons to change the value, and use the and buttons
to switch the characters to be changed.
Press the ENTER button when the setting is completed.
Channel
Select the channel for use. It is necessary to select the same channel as used by
the wireless card of the PC with which the projector communicates.
In the INFRASTRUCTURE mode, the projector usually operates regardless of the
channel setting. However, communication may not be established depending on
the access point used unless the projector has the same channel setting as the
access point.
Use
and buttons to select the desired channel and press the ENTER
button.
Note:
• Available channels vary by the country (refer to page 87 ).