Panasonic TQBH9003-6 - Manual (Page 26)

26
Example of connecting to video equipments
USB
DVI-D IN
REMOTE
SERIAL RGB1 IN RGB2 IN/RGB OUT
AUDIO OUT
RGB AUDIO IN VIDEO IN AUDIO IN
S-VIDEO IN
R
L
R/R-Y/P R VD SYNC/HD B/B-Y/P B
RGB3 IN
G/Y
D-sub 15 (male) - BNC5 (female)
adapter cable (sold separately)
Red (connect to P
R
signal connector)
Blue (connect to P
B
signal connector)
Green (connect to Y signal connector)
Digital broadcast
tuner or DVD player
D-sub 9-pin
(male)
DVD player Audio system
Video deck
NOTE:
B Only one audio system circuit is available for the AUDIO IN L-R jacks for
S-VIDEO/VIDEO signals, so if you wish to change the audio input source,
you will need to remove and insert the appropriate plugs.
B Only one audio system circuit is available for the RGB AUDIO IN jacks, so
if you wish to change the audio input source, you will need to remove and
insert the appropriate plugs.
B If an audio system is connected to the AUDIO OUT jack, the sound
volume balance can be controlled by the remote control unit which is
supplied with the projector.
B If the video signal source is connected using a cable with a BNC
connector plug, use a BNC/RCA adapter (sold separately) to convert the
cable end to an RCA plug-type jack.
B Refer to page 63 for a list of compatible YP
B
P
R
signals which can be input
to the projector.
B If the signal cables are disconnected or if the power supply for the
computer or video deck is turned off while the digital zoom function is
being used, this function will be cancelled.
Computer for
control use
DVD player
Red (connect to P
R
signal connector)
Blue (connect to P
B
signal connector)
Green (connect to Y signal connector)