Pioneer VSX-C301 - Manual (Page 29)

Using other functions 08
29
En
English Chapter 8
Using other functions
Selecting the input signal type
The DVD , STB , DVR/TV and FRONT inputs all have both
analog and digital jacks. You can select the type of signal
to be used in each case. The input signal type for the
current input is indicated in the display:
ANA (analog),
DIG (digital).
The default AUTO setting is usually sufficient, letting the
receiver decide the most suitable signal type. However, if
you want to record from the
VIDEO IN/OUT AV
connector or the DVR/TV IN/OUT AV connector, then
you should set the input signal type to analog.
• Press SIGNAL SELECT to change change the input
signal type.
• SEL. AUTO – (default setting) Uses digital if
available, otherwise analog
• SEL. ANA – Uses the analog signal
• SEL. DIG – Uses the digital signal
• When the VIDEO or FM/AM inputs are used, the
display always shows ANA (analog).
Using the sleep timer
The sleep timer automatically puts the receiver into
standby after the specified period of time.
• Press SLEEP (RECEIVER + AV DIRECT) to set the
sleep timer.
Press repeatedly to select between:
• 90 MIN. – Switches to standby after 90 minutes
• 60 MIN. – Switches to standby after one hour
• 30 MIN. – Switches to standby after 30 minutes
The sleep timer indicator ( ) lights when the sleep timer
has been set.
• The sleep timer is cancelled if you switch on the AV
Direct function. See also on page 9 and AV Direct
setting on page 33.
• Press the SLEEP ( RECEIVER + AV DIRECT ) button
once to view how much time is left on the timer
before shutdown. Each press after that will cycle
through the possible sleep time lengths.
Resetting the system
Use this feature to reset the system to its factory default
settings.
1 Press RECEIVER.
2 In standby, press ROOM SETUP and SYSTEM
SETUP at the same time.
The display prompts you to confirm.
3 Within 5 seconds, press LEVEL –.
The display shows OK .
4 Within 5 seconds, press LEVEL +.
The receiver should now be reset.
• If the receiver is disconnected from the power outlet
for more than a month it will reset to the default
settings.
• The above reset doesn’t affect the presets that you
have programmed into the remote control (see Using
the remote control with other components on
page 34).
INPUT VIDEO FRONT FM/AM
SURROUND ADVANCED
SURROUND
SOUND MODE SIGNAL
SELECT DIALOG
AUTO STEREO
LEVEL TEST TONE CH SELECT
MUTE
MASTER
VOLUME
DTV MENU
TOP MENU T.EDIT
MENU
ROOM
SETUP
TUNE
ST ST
SYSTEM SETUP
SOURCE RECEIVER
SLEEP
RECEIVER
AV DIRECT
INPUT
DVD
VIDEO
STB
FRONT FM/AM
DVR/TV
SURROUND
ADVANCED
SURROUND
AUTO STEREO
LEVEL TEST TONE CH SELECT
SOURCE RECEIVER
SLEEP
RECEIVER
AV DIRECT
INPUT
DVD
VIDEO
STB
FRONT FM/AM
DVR/TV
SURROUND
ADVANCED
SURROUND
SOUND MODE SIGNAL
SELECT DIALOG
AUTO STEREO
LEVEL TEST TONE CH SELECT
MUTE
MASTER
VOLUME
DTV MENU
TOP MENU T.EDIT
MENU
ROOM
SETUP
TUNE
ST ST
SYSTEM
SETUP
ENTER
vsx-c301.book 29 ページ ２００３年２月６日 木曜日 午後５時４分