Troubleshooting, Additional information, English – Pioneer VSX-C301 User Manual

Page 39: Additional information 11, Chapter 11

Advertising
background image

Additional information

11

39

En

English

Chapter 11

Additional information

Troubleshooting

Incorrect operations are often mistaken for trouble and
malfunctions. If you think that there is something wrong
with this component, check the points below.
Sometimes the trouble may lie in another component.
Investigate the other components and electrical

appliances being used. If the trouble cannot be rectified
even after exercising the checks listed below, ask your
nearest Pioneer authorized service center or your dealer
to carry out repair work.

Symptom

Cause

Remedy

The power does not turn on.

• The power plug is disconnected.

• Connect the power plug to the wall outlet.

• The protection circuit may have been
activated.

• Disconnect the power plug from the outlet, and insert
again.

• Static electricity caused by dry air.

• Disconnect the power plug from the outlet, and insert
again.

• Something is obstructing the rear panel fan. • Remove the obstruction then press

STANDBY/ON

for

10 seconds to switch on.

• The internal temperature of the unit has
become too high.

• Place the unit in a cool, airy place to cool it down, then
press

STANDBY/ON

for 10 seconds to switch on.

The receiver suddenly switches
off.

• The internal temperature of the unit has
become too high.

• Allow the unit to cool down in a well ventilated place,
then press

STANDBY/ON

for 10 seconds to switch on.

• The thermistor (temperature sensor) is
faulty.
• The receiver has a serious problem.

• Unplug the receiver from the wall and call a Pioneer-
accredited repair center.

AMP ERR

is displayed, then the

power automatically switches off.

• The receiver has a serious problem.

• Unplug the receiver from the wall and call a Pioneer-
accredited repair center.

Do not try to switch the unit on/

off again after seeing this message.

The unit does not respond when
the buttons are pressed.

• Improper connections.

• Make sure the component is connected correctly (see
page 8).

• Sound is muted.

• Press

MUTE

on the remote control.

• The volume is turned down.

• Adjust the

MASTER VOLUME

.

No sound is output when the
AM/FM is selected.

• Incorrect frequency.

• Tune in the correct frequency.

• The antenna is not connected.

• Connect the antenna (see page 15).

Broadcast stations cannot be
selected automatically.

• The radio signal is too weak .

• Connect an outdoor antenna (see page 15).

Considerable noise in radio
broadcasts.

FM broadcasts

• The FM antenna is not fully extended or is
poorly positioned.

• Fully extend the FM wire antenna, position for best
reception, and secure to a wall.

• Weak radio signals.

• Connect an outdoor FM antenna (see page 15).

AM broadcasts

• The AM antenna is poorly positioned.

• Adjust the direction and position for best reception.

• Weak radio signals.

• Connect an additional internal or external AM antenna
(see page 15).

• Interference caused by other equipment
(fluorescent lamp, motor, etc.).

• Turn off the equipment causing the noise or move it
away from the receiver.

• Place the antenna farther away from the equipment
causing the noise.

No sound from surround or
center speakers.

• Surround or center speaker settings are
incorrect.

• Refer to

Making receiver settings from the System Setup

menu

on page 31 to check the speaker settings.

• The surround and/or center levels are
turned down.

• Turn levels up. See on page 33 to check the speaker
levels.

• The surround and/or center speakers are
disconnected.

• Connect the speakers (see page 13).

vsx-c301.book 39 ページ 2003年2月6日 木曜日 午後5時4分

Advertising
This manual is related to the following products: