Philips WAC5 - Manual (Page 17)

17
English
Preparation
Using the remote control
IMPORTANT!
– Always point the remote control
directly towards IR area on the Center or
Station you wish to operate.
– Some functional keys on Center’s
remote control are exclusively used for
Center (for example, CD/MP3-CD,
MARK/UNMARK, MUSIC BROADCAST
etc.)
Preparation
Center’s remote control:
1
Open the battery compartment.
1
3
2
2
Insert 4 batteries type R03 or AAA into the
remote control with the correct polarity as
indicated by the "
+" and "-" symbols inside
the battery compartment
3
Put back the compartment door
CAUTION!
– Remove batteries if they are
exhausted or will not be used for a long
time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed of properly.
Using Center’s remote control
Battery usage: As a remote control with
synchronous display, Center’s remote control
consumes more power than normal remote
controls. When its batteries are low or empty, the
icon appears on the remote control’s display.
Replace the batteries with new alkaline batteries.
By default, Center’s remote control works with
Center only.
To operate Station using
Center’s remote control
1
Press and hold REFRESH until the selection
screen appears on the display of Center’s
remote control.
2
Press the navigation controls 3 or 4 and 2
to select
Station
On Center’s remote control:
➜ Display shows current status of Station
after Station is connected
➜
You can use Center’s remote control to
operate Station now.
p001-p037_WAC5_Eng_22 9/14/2005, 15:08 17