Patton electronic SmartNode 2294 - Manual (Page 17)

SmartNode Series Leased-Line Extenders overview 17
Model 2292 & 2294 Series Getting Started Guide 1 • General information
Figure 3. SmartNode 2294 power input connectors
Ports descriptions
The SmartNode 2292 Series rear panel ports are described in
table 2 .
Reset button behavior
The SmartNode devices have a Reset button on the rear panel. It is used as follows:
• To restart the unit with the current startup configuration—Press for less than 1 second and release the Reset
button. The SmartNode will restart with the current startup configuration.
• To restart the unit with factory default configuration—Press the Reset button for 5 seconds until the Power
LED starts blinking. The unit will restart with factory default configuration.
Table 2. Rear panel ports
Port Location Description
10/100 Ethernet
ETH 0/0 & ETH 0/1 Rear panel RJ-45 connectors (see figure 6 on page 26) that connect the extender to an
Ethernet device (e.g., a cable or DSL modem, LAN hub or switch).
Analog voice port Rear panel FXS RJ-11(6 position, 4 wire) connectors (see figure 6 on page 26) that
connect the extender with an analog terminal.
Power Rear panel The gateway is available in a DC or AC power input version (see
figure 3 ), labeled as follows:
• AC version (Internal power supply): 100–240 VAC, 50/60 Hz, 200 mA
• DC version: 12 VDC, 1.25 A
Console Front panel Used for service and maintenance, the Console port (see figure 4 on page 18),
an RS-232 RJ-45 connector, connects the extender to a serial terminal such as a
PC or ASCII terminal (also called a dumb terminal).
External power supply connector (accepts 12 VDC, 1.25 A, from external AC adapter)
, 1.25A
Reset
Ports
ETH 0/1
ETH 0/0
, 1.25A Reset
Ports
ETH 0/1 ETH 0/0