Patton electronic SmartNode 2294 - Manual (Page 35)

Configure the IP address 35
Model 2292 & 2294 Series Getting Started Guide 4 • Getting started with the SmartNode
Login
1. Accessing your SmartNode via the local console port (or via a Telnet session) causes the login screen to dis-
play. Type the factory default login: administrator and leave the password empty. Press the Enter key after
the password prompt.
login:administrator
password: <Enter>
172.16.40.1>
2. After you have successfully logged in you are in the operator execution mode, indicated by > as command
line prompt. With the commands enable and configure you enter the configuration mode.
172.16.40.1>enable
172.16.40.1#configure
172.16.40.1(cfg)#
3. Enter the following commands for the first SmartNode 229x device in the pair:
Copy nvram:a-side-config startup-config
Copy running-config startup-config
4. Follow the same procedure for the other SmartNode 229x device in the pair:
Copy nvram:b-side-config startup-config
Copy running-config startup-config
Note The configuration above is only a sample configuration that you may use as
an example. You should specify your own parameters such as your IP address
and other related parameters as required. For detailed information about
configuring and operating your SmartNode, set-up procedures, and trouble-
shooting, refer to the SmartNode Series SmartWare Software Configuration
Guide on the CD-ROM that came with your unit.
5. Reboot both units and connect them back-to-back through their Ethernet 0/1 ports. Voice connections
will automatically be set up between the units.
The steps above will configure the IP addresses as well as the required configurations for voice connections.