Patton electronic SmartNode 2294 - Manual (Page 48)

Ethernet 10Base-T and 100Base-T 48
Model 2292 & 2294 Series Getting Started Guide C • Cabling
Ethernet 10Base-T and 100Base-T
Ethernet devices (10Base-T/100Base-T) are connected to the SmartNode over a cable with RJ-45 plugs. Use a
cross-over cable to a host, or a straight cable to a hub. See
figure 18 (host) and figure 19 on page 49 (hub) for
the different connections.
Note The SmartNode 2292 Series is equipped with Auto-MDX Ethernet ports.
Use straight-through wired cables for host or hub/switch connections
Figure 18. Ethernet cross-over
Host
Cross-over cable
RJ-45, male
Tx+
Tx-
Rx+
Rx- 1
2
3
6
RJ-45,
1 TX+
2 TX-
3 RX+
6 RX-
Twisted pair 1
Twisted pair 2
, 1.25A
Reset
Ports
ETH 0/1
ETH 0/0