Patton electronic SmartNode 2294 - Manual (Page 26)

Installing the SmartNode extender 26
Model 2292 & 2294 Series Getting Started Guide 3 • Hardware installation
Installing an interface cable on the extender’s voice ports
The SmartNode extender comes with at least two voice ports (see
figure 6 ) located on the back of the extender.
The voice ports are connected to analog devices via cables (see figure 7 ) terminated with RJ-11 connectors (see
figure 9 and table 5 on page 27 for pin-out information).
Figure 6. Rear view showing location of Ethernet connectors and voice ports (SmartNode 2294 shown)
Figure 7. Analog connection
, 1.25A Reset
Ports
ETH 0/1 ETH 0/0
Ethernet connectors Voice ports
, 1.25A
Reset
Ports
ETH 0/1
ETH 0/0
RJ-11, male RJ-11, male
, 1.25A
Reset
Ports
ETH 0/1
ETH 0/0