Patton electronic SmartNode 2294 - Manual (Page 34)

Configure the IP address 34
Model 2292 & 2294 Series Getting Started Guide 4 • Getting started with the SmartNode
Configure the IP address
Power connection and default configuration
First the SmartNode must be connected to the mains power supply with the power cable. Wait until the 'Run'
LED stops blinking and lights constantly. Now the SmartNode is ready.
The factory default configuration for the Ethernet interface IP addresses and network masks are listed in table 7 .
Both Ethernet interfaces are activated upon power-up.
Connect with the serial interface
The Console port is wired as an EIA-561, RS-232 port. Use the included Model 16F-561 adapter and cable (see
figure 15 ) between the SmartNode’s Console port and a PC or workstation’s RS-232 serial interface. Activate the
terminal emulation program on the PC or workstation that supports the serial interface (e.g. HyperTerm).
Figure 15. Connecting to the terminal
Terminal emulation program settings:
• 9600 baud
• no parity
• 8 bit
• 1 stop bit
• 1 start bit
• No flow control
Table 7. Factory default IP address and network mask configuration
IP Address Network Mask
Interface Ethernet 0 (ETH0) DHCP DHCP
Interface Ethernet 1 (ETH1) 192.168.1.1 255.255.255.0
Serial Terminal
Note A Patton Model 16F-561 RJ45 to DB-9 adapter is included with
each SmartNode Series device
Link 100M
Activity
0/0
0/1 0/2
0/3
En et 0
Po rts
Power
Console Le as ed -L in e Ex te nd er O ve r I P
SmartNode 2294
Run
V oIP
Link
Link 100M
Activity
En et 1