Pride Mobility Jazzy Select Series - Manual (Page 21)

Select Traveller www.pridemobility.com 21
Seat Installation
It may be necessary to install the seat either prior to
initial operation or after transporting your power chair.
The seat is attached to the power base by a height-
adjustable seat pedestal.
WARNING! Do not pick up the seat
frame by the armrests. They are free to
pivot, and you may lose control of the
seat if they do so.
To install the seat:
1. Adjust the seat height if necessary. See V.
“Comfort Adjustments.”
2. Set the seat onto the seat pedestal. See figure 9.
3. Install the controller into the armrest, and tighten
the setscrew under the armrest.
4. Lift the armrest straight up, then route the
controller harness and secure with wire ties as
shown in figure 9.
MANDATORY! Prevent controller
harness damage! Use correct tie-down
points for controller harness. Avoid
routing the controller harness on the
outside of the armrest pad. Route the
harness under the armrest or toward
the inside of the armrest pad. Use
correct tie-down points for the
controller harness to prevent the
harness from getting caught in the
drive tires, pinched in the seat frame,
or damaged when passing through
doorways.
5. Plug the controller harness into the connector on
the power base. See figures 6 and 9.
I V . A S S E M B L Y
Figure 9. Seat Installation
WIRE TIES