Pride Mobility Jazzy Select Series - Manual (Page 23)

Select Traveller www.pridemobility.com 23
V . C O M F O R T A D J U S T M E N T S
Figure 12. Armrest Width Adjustment
ARMREST
KNOBS
Figure 13. Armrest Angle and Height Adjustment
SETSCREW
ARMREST
HEIGHT
ADJUSTMENT
SETSCREWS
ARMREST
ANGLE
ADJUSTMENT
SCREW
JAM NUT
Armrest Width Adjustment
You can change each armrest’s width independently of
the other.
NOTE: Changing the armrest width may increase
the overall width of your power chair.
To change the armrest width:
1. Locate the two armrest knobs on each side of the
armrest receiver bracket. See figure 12.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the knobs.
Armrest Angle Adjustment
To change the armrest angle:
1. Lift the armrest straight up so that it is
perpendicular to the floor. See figure 13.
2. Loosen the jam nut.
3. Turn the adjustment screw to raise or lower the
front of the armrest.
4. Tighten the jam nut to lock the adjustment screw
into place.
Armrest Height Adjustment
To change the armrest height:
1. Loosen the setscrews on the armrest. See
figure 13.
2. Raise or lower the armrest to the desired height.
3. Tighten the setscrews to secure the armrest.
Controller Position
You can move the controller in toward or out away
from the armrest, or change the position of the control-
ler for either left-hand or right-hand use.
WARNING! Do not place the controller
harness so that it can be pinched in
the seat frame or the power base
frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the
floor.
2. Loosen the setscrew on the controller bracket. See
figure 13.
3. Slide the controller into or out of the armrest to the
desired position.
4. Tighten the setscrew to secure the controller.
CONTROLLER
BRACKET