Pride Mobility Jazzy Select Series - Manual (Page 32)

32 www.pridemobility.com Select Traveller
WARNING! The batteries in your power chair should only be serviced or replaced by
an authorized Pride Provider or a qualified technician.
WARNING! Do not replace batteries when seat is occupied.
WARNING! Power chair batteries are heavy. See specifications table. If you are
unable to lift that much weight, be sure to get help. Use proper lifting techniques and
avoid lifting beyond your capacity.
WARNING! Do not mix old and new batteries. Always replace both batteries at the
same time.
PROHIBITED! Keep tools and other metal objects away from the battery terminals.
Contact with tools can cause electrical shock.
Battery Replacement
A battery wiring diagram is printed on a decal located
on the front battery tray. See the Specifications Table
for correct battery specifications.
MANDATORY! Battery
posts, terminals, and
related accessories
contain lead and lead
compounds. Wear goggles
and gloves when handling
batteries and wash hands
after handling.
V I I . C A R E A N D M A I N T E N A N C E
Figure 17. Battery Cover Removal
Figure 16. Select Traveller Drive Wheel
DRIVE WHEEL NUT
DRIVE WHEEL WASHER
AXLE KEY
AXLE SLOT
To replace the wheel:
1. Turn off the power to the controller.
2. Set the power chair up on blocks.
3. Remove the drive wheel nut and washer from the
axle. See figure 16.
4. Pull the wheel off the axle. Make sure that you
keep the axle key.
5. Slide the new wheel back onto the shaft. Make
sure that the key is in the axle slot.
WARNING! Failure to ensure that the
axle key is properly installed into the
axle slot when mounting the wheel
can result in electronic brake failure,
personal injury, and/or product
damage.
6. Reinstall the drive wheel nut and washer onto the
axle and tighten.
WARNING! Make sure both the nut
and washer are reinstalled and
tightened properly.
7. Remove the power chair from the blocks.