Paxar Monarch DOS-based Pathfinder Ultra System 6035 - Manual (Page 39)

Designing a Format 4-7
P l a c i n g F i e l d s o n a F o r m a t
You must be careful where you place a field on a format to ensure it does
not go off the format. There are two ways this can occur. You have placed
the field
♦ on the format, but based on its maximum length, it may go off the edge.
This way causes the software to display a warning, which you can ignore.
See Chapter 3, “Configuring the Printer,” to learn how to suppress the
display of warnings if you prefer to do so.
♦ completely off the format.
This way causes an error. You must redefine the field.
NOTE: Remember that the field can go off the format on any of the four
sides (top, bottom, left, right).
See Chapter 12, “Troubleshooting,” to learn about this error and warning.