POLAR S810 - Manual (Page 21)

B 38 C 39
Time of day
Heart rate measure mode
Exercise recording mode
You can use two modes in your
exercise: Measure or Exercise mode.
In the Measure mode you can see your
heart rate but your exercise is not
recorded. In the Exercise mode your
exercise is recorded and stopwatch
and other calculations are started.
1. Wear the transmitter and the wrist receiver as described in “Easy start” section.
2. To make sure that the code search will be successful:
•
Keep the wrist receiver within 1 metre/ 3 feet of your transmitter.
• Check that you are not near to other people with heart rate monitors,
high voltage power lines, televisions, mobile phones, cars, motor driven
exercise equipment or other electromagnetic disturbance.
Heart rate measure mode
C. EXERCISE
Swap time 1 or time 2
In the Time of day display press and hold the down button. Time 1 or
Time 2 is displayed in the uppermost row for a couple of seconds. Displayed
time will now be used in all watch and alarm functions. If you chose time 2,
“2” is displayed in the Time of day display.
Shortcut to watch setting loop
Press and hold the signal/light button for a couple of seconds to enter to
watch setting loop. If you want to skip some parts and go directly to set a
particular watch function, scroll up or down button until the desired watch
function is displayed. Set the function as in the “Watch settings” section.
Swap measuring units
As you set your user information on weight and height press and hold the
signal/light button until the units are swapped. Release the button.
Swap date, user ID, user name and logo
You are able to set a user ID number, user name and logo by Polar Precision
Performance software. These settings are shown on the upper row of the
Time of day display. You can swap between the user ID, user name, logo
and date by pressing and holding the up button.
You can upload 7 reminders, each including time and name, to your wrist
receiver from Polar Precision Performance software.
The reminder sounds an alarm only when time of day is displayed. When
the reminder alarm comes on, it will sound for 15 seconds or you can turn it
off by pressing any of the buttons except the signal/light button.
Erase the reminder text by pressing any of the buttons except the
signal/light button.
To continue your settings, press the stop button or to return to the Time of
day display, press and hold the stop button.
Setting tips
S810 manual GBR A.pm6 23/4/01, 15:53 38-39