Powerware 9 - Manual (Page 37)

Installation
31 Powerware ® 9 Prestige Series User’s Guide (600 VA - 1800 VA)
:
www.powerware.com
Air
Exhausts
Breaker
Serial
Port
Input Connector
Battery Input Connector Battery Output
Connector External Battery Connector
Power Output
Receptacles
UPS Cabinet Battery Cabinet
Battery Cable
Battery
Circuit Breaker
Breaker Tie
Figure 4. Typical UPS Rear Panel
UPS Startup for 120V Models
To start up the UPS for 120V models:
1. Plug the UPS power supply cord into the input connector on
the UPS rear panel.
2. Plug the other end of the power supply cord into a grounded,
three-wire, AC receptacle that has been wired in accordance
with NEC specifications.
The UPS performs diagnostic tests and enters Normal mode
with the equipment (load) offline. The

indicator remains
lit. The startup should take about 15 seconds.