Panasonic AJ-HD1700PE - Manual (Page 25)

25
Recording
1
Set the accidental erasure prevention tab on the
cassette tape to the “recording” position, and insert
the tape.
3
Select “EE” as the OUTPUT setting using on
the <HOME> menu. E-E pictures now appear on
the TV monitor.
F1
4
Check that the REC INHIBIT lamp is off.
If the lamp is lighted, select “OFF” as the R INH
setting using
on the <HOME> menu.
If the inserted cassette has already been recorded
on using a format other than DVCPRO HD-LP, the
recording inhibited status (factory setting) will be
set by setup menu item No.118.
F6
6
Press the PLAY button while holding down the
REC button.
The REC and PLAY lamps light, and recording
starts.
7
When the STOP button is pressed, the recording
ends, and the VTR is set to the stop mode.
<Notes>
• During recording, check that the SERVO lamp is
lighted. The playback pictures will be disturbed if it
is blinking or off.
• If analog signals (ANA1 to ANA4) have been
selected as the CH5 to CH8 input signals on the
AUDIO menu, their recording levels are tied in with
the recording levels which have been set for the
CH1 to CH4 signals.
• When SDTI has been selected as the video signals
to be recorded, the audio signals which will be
recorded are also automatically set to SDTI.
5
Select the video and audio input signals, and
adjust the audio levels.
Selecting the video and audio input signals
1
Connect the signals to be recorded.
2
Select the input signals using on the
<VIDEO> menu and to on the
<AUDIO> menu or <AUDIO SHIFT1> menu.
Adjust the audio levels
1
Adjust the audio input levels of the CH1, CH2,
CH3, CH4, CH5, CH6, CH7, CH8 audio signals
and analog cue signal selected on the AUDIO
menu.
When the audio UNITY lamp on the front panel
is lighted, the audio signals will be recorded at
the appropriate levels.
2
Before adjusting the recording level, check that
the REC LED is lighted and that the audio
adjustment dial is in the unlocked status (LOCK
LED off).
If the dial is in the LOCK status (LOCK LED
lighted), press it. The LOCK LED goes off, and
the lock is released.
In addition, the analog cue audio recording level
is adjusted using setup menu item No.790 (CUE
REC VOL) so that it will not exceed
j 20 dB.
F6 F1
F1
2
Press the STOP button to set the VTR to the stop
mode.