Panasonic AJ-HD1700PE - Manual (Page 36)

36
Variable memory function
1
Register the IN point using the SET button and IN
button. There is no need to set the OUT point for
variable memory playback.
Variable memory playback operation procedure
The variable memory mode can be selected by setting
(VARMEM) on the <HOME SHIFT> menu to
“ON.”
When
(VARMEM) is set to “OFF,” the variable
memory mode is canceled, and the regular mode is
established.
<Note>
Bear in mind that when the 23/24 Hz or 25 Hz (HD or
SD) mode has been selected as the system menu
item No.25 (SYSTEM FREQ) setting,
(VARMEM)
will no longer appear on the display and the variable
memory mode cannot be selected.
F6
F6
F6
2
Set the initial speed ( j 1.0 k to i 2.0 k ) using the
search dial while holding down the SET button.
3
When the SET button and PREVIEW/REVIEW
button are pressed at the same time, the tape is
automatically prerolled and played back at the
initial speed setting up to the IN point.
4
After the tape has passed the IN point, turn the
search dial to store the playback speed in the
memory.
5
Press the STOP button to stop the tape.
6
When the PREVIEW/REVIEW button is pressed,
variable memory playback is performed at the
memorized speed.
Variable memory function selection
This VTR is provided with two variable memory
functions, as follows. These functions can be used in
the variable memory mode.
Variable memory playback:
Any section of the tape can be played back at variable
speeds in the VAR mode, the changes in the speed
can be stored in the memory, and the tape can be
played back at the memorized speed.
Variable memory editing:
Using the VTR as a controller (recorder in the deck-to-
deck mode) to control the playback speed of the
player, editing can be performed in the variable speed
mode.
Outline
To perform variable memory playback operations, set
the VTR to the variable memory mode, and take the
steps below.
<Notes>
• After passing the IN point, the tape is played back
in accordance with the settings in the memory, and
it continues to run at the last speed stored in the
memory until the STOP button is pressed.
• Whatever is stored in the memory will be cleared
when the VTR exits the variable memory mode. It
is also cleared when the POWER switch is set to
“OFF.”
POWER OFF ON
HEADPHONES
PUSH
LOCK
FULL
CH CONDITION MONITOR FULL/FINE REMOTE
L R 9P50P RS-232C
CH 1 2 3 4 5 6 7 8 CUE
XL/L/M-cassette
Do not insert S-cassette without adapter
EJECT
AUDIO CH SELECT
SHIFT
ABC DEF GHI
JKL MNO PQRS
PREVIEW/
REVIEW
PRE-
ROLL
A IN A OUT
HOME RF1 ASSEM ADJUST SHTL
REV FWD
VAR JOG
STAND BY RECORDER INPUT CHECK PLAYER
SERVO
EDIT PLAY REC
REW STOPFF
REC INHIBIT
PUSH-INTER
INSERT
RF2
VIDEO UNITY TC CUE
AUDIO UNITY DIAG MENU
TRIM
SET
IN OUT
AUTO EDIT
7 8 9
4 5 6 BS
TUV WXYZ
1 2 3 ENT
0 C T F
F1 F2 F3 F4 F5 F6
CH 1 CH 5 CH 2 CH 6 CH 3 CH 7 CH 4 CH 8
FULL REC P8 REC P8 REC P8 REC P8
1
5 6 4
2
3