Function menus, Home, Registering tcg values 1. 2. 3 – Panasonic AJ-HD1700PE User Manual

Page 45

Advertising
background image

45

<HOME>

Registering TCG values

1.

2.

3.

Selecting the values
Press the TC/CTL button to select TC.
Press the

button. The selected item (cue time

or TC) is now highlighted.
Turn the ADJUST dial to select TC.
Again press the

button. A single digit is

highlighted, and the mode for inputting numerical
values is established.
<Notes>
• The UBG value and cue time can be registered

in the same way. The CTL value cannot be
registered.

• TC or UB can be registered only when the

internal time code generator has been selected.

T

T

Inputting numbers and letters
Press the

to

number keys to input

numerical values.
Use the

+

buttons to input A, B and C, and

the

+

buttons to input D, E and F.

To move the input digit, turn the ADJUST dial.
To input a minus sign, press the

and

]

buttons when the left-most digit is highlighted.
To input a plus sign, press the

and

]

buttons when the left-most digit is highlighted or
press the

button.

(The display goes blank.)
To clear all the digits to zero, press the

and

buttons.
<Notes>
• When the

button is tapped while the

button is held down, the display changes in the
following sequence: A

>

B

>

C

>

A

>

B and

so on. The same applies when D, E and F are
input using

and

.

• If, when “REV” has been selected as the setup

menu item No.144 (TC INPUT) setting, the
button is released while a letter is being input,
the displayed character will be entered.

• Letters can be input only while a UBG value is

being registered.

• The input of a minus number is possible only

while the cue time is being registered after

d

12h” is selected as the setup menu No.002

(TAPE TIMER) setting and CTL is selected by
the

TC/CTL button.

• If “REV” has been selected as the setup menu

item No.144 (TC INPUT) setting, the input
starts from the highest order digit (the display
appears from the far right). However, turning
the ADJUST dial once will restore the NORMAL
input mode.

F3

F

8

F

F

7

0

F

0

TRIM

i

F

TRIM

j

F

8

F

7

F

9

0

Entering the input values
Press the

button. The value input is

registered, and the normal display is restored.
<Notes>
• To cancel the registration, press the

button.

• If the input value is outside the registration

enable range, the

alarm blinks, and

the value cannot be registered until it has been
corrected.

INVALID

C

ENT

Function menus

HOME

F3

Advertising