Panasonic PT-AE2000U - Manual (Page 19)

E
NGLISH - 19
Basic O
p
eration
Switching the projector on/off
J Connecting
1. Make sure the shape of
the power plug and the
AC IN connector on the
back of the projector
match, then push the plug all the way in.
2. Connect the power cord to a wall outlet.
J Disconnecting
1. Make sure the MAIN POWER is switched off and
unplug the power cord from the wall outlet.
2. Hold the plug and unplug the power cord from the
AC IN connector on the side of the projector.
Power cord
NOTE:
• Do not use other than the provided power cord.
• Ensure all the input devices are connected and turned off before connecting the power cord.
• Do not force the connector as this may damage the projector and/or the power cord.
• Dirt or dust build-up around plugs may cause fire or electrical hazards.
• Switch off the power to the projector when not in use.
POWER indicator
Indicator status Status
No illumination or flashing The MAIN POWER button is switched off.
Red Lit The MAIN POWER button is switched on and the projector is in standby.
Green
Flashing The POWER button is switched on and the projector is getting ready to project.
Lit The projector is ready to project.
Orange
Lit The POWER button is switched off and the projector is cooling the lamp.
Flashing
The POWER button is switched on again when cooling the lamp and recovering to
projection mode. Recovery may take a while.
NOTE:
• While the projector is cooling the lamp, do not switch the MAIN POWER button off or unplug the power cord.
• The electric consumption in standby mode is 0.08 W.
POWER indicator