Position menu, H-position, V-position – Panasonic PT-AE2000U User Manual
Page 36: Dot clock, Clock phase, Aspect, H-position v-position dot clock clock phase aspect, H-position v-position dot clock, Nglish, Jaspect ratio depend on signals
36 -
E
NGLISH
Settings
POSITION menu
You can move the projected image horizontally for fine
adjustment.
You can move the projected image vertically for fine
adjustment.
If you have interference patterns of the projected image,
which is sometimes referred to as moire or noise, you
can minimize it by pressing I H to adjust the clock
frequency. (Available with signals from COMPUTER IN
only)
If you require further adjustment for the same reason as
the DOT CLOCK adjustment, you can fine adjust the
timing of the clock. Press I H to adjust. (Available with
signals from COMPUTER IN/COMPONENT IN only)
You can switch the aspect ratio manually when needed.
J
Aspect ratio depend on signals
Press I H to cycle through the aspect ratio
options. The cycle pattern depends on the
connected signals.
H-POSITION
V-POSITION
DOT CLOCK
NOTE:
• If the projecting signal’s dot clock frequency is higher
than 150 MHz, the adjustment may not make a
difference.
• DOT CLOCK needs to be adjusted before adjusting the
CLOCK PHASE.
Remote control
Control panel
See “Navigating through the MENU” on page 30.
See “Main menu and sub-menu” on page 28.
Move
right
Move left
Move up
Move
down
CLOCK PHASE
NOTE:
• If the projecting signal’s dot clock frequency is higher
than 150 MHz, the adjustment may not make a
difference.
• Available signals from COMPONENT IN:
1 125 (1 080)/60i, 1 125 (1 080)/50i, 1 125 (1 080)/60p,
1 125 (1 080)/50p, 1 125 (1 080)/24p, 750 (720)/60p
ASPECT
VIDEO/
S-VIDEO
4:3 \ 16:9 \ 14:9 \ ZOOM1 \
ZOOM2 \ JUST
AUTO \ 4:3 \ 16:9 \ JUST \ ZOOM
NTSC signal
COMPUTER
(RGB)
4:3 \ 16:9
4:3 \ 16:9
VGA or SVGA signals
Not switchable
WIDE480/600/720/768/768-2/800/900
signals
HDMI
4:3 \ 16:9
16:9 \ H - FIT \ V - FIT \ ZOOM
1 125 (1 080)/50i, 1 125 (1 080)/60i,
1 125 (1 080)/50p, 1 125 (1 080)/60p,
1 125 (1 080)/24p, 750 (720)/50p and
750 (720)/60p signals
4:3 \ 16:9 \ JUST \ ZOOM
525p (480p) and 625p (576p) signals
COMPONENT
(YP
B
P
R
)
4:3 \ 16:9 \ 14:9 \ JUST \ ZOOM1
\ ZOOM2
625i (576i), 625p (576p)
AUTO \ 4:3 \ 16:9 \ JUST \ ZOOM
525i (480i), 525p (480p)
16:9 \ H - FIT \ V - FIT
1 125 (1 080)/50i, 1 125 (1 080)/60i,
1 125 (1 080)/50p, 1 125 (1 080)/60p,
1 125 (1 080)/24p, 750 (720)/50p,
750 (720)/60p signals