ParaBody 880 - Manual (Page 10)

STEP 8:
FIGURE 8
• Remove the 3-1/2” PULLEY, one 3/8 X 3-3/4” BOLT, two 3/8 X 1” SPACERS and one 3/8” LOCK NUT from the BASE PLATES as
shown in FIGURE 8. Discard one of the 3/8 X 1” SPACERS.
3/8 X 3-3/4”
2
BASE PLATES
10
0 1 2 3 4 5 6
1/2 1/2 1/2 1/2 1/2 1/2
STEP 9:
FIGURE 9
• SECURELY assemble the previously removed 3-1/2” PULLEY, one previously removed 3/8 X 1” SPACER and one 3-1/2” PULLEY
(4) to the BASE PLATES using one previously removed 3/8 X 3-3/4” BOLT and one 3/8” LOCK NUT. See FIGURE 9.(Note: Loop
the SHORT LEG PRESS CABLE (2) around the PULLEY prior to assembling the PULLEY to the BASE PLATES.)
4
3/8 X 3-3/4”
BASE PLATES
2