ParaBody 880 - Manual (Page 19)

STEP 2:
FIGURE 2
19
• Route the LONG LEG PRESS CABLE (3) around the 3-1/2” PULLEY on the PULLEY PLATES using one existing 3/8 X 1-3/4”
BOLT and one existing 3/8” LOCK NUT. See FIGURE 2.
STACK
BASE
PULLEY PLATES
• Assemble the LONG LEG PRESS CABLE (3) to the PEDESTAL and route the LONG LEG PRESS CABLE (3) thru the BASE
FRAME as shown in FIGURE 2. (NOTE: Remove pulleys for ease of installation.)
3
3/8 X 1-3/4”
SHORT LEG
PRESS CABLE
• Route the LONG LEG PRESS CABLE (3) around 3-1/2” PULLEY (4) and assemble to the bracket on the STACK BASE using one
existing 3/8 X 1-3/4” BOLT and one existing 3/8” LOCK NUT. See FIGURE 2.
4