Pride Mobility JAZZY 1101 - Manual (Page 20)

20 www.pridemobility.com Jazzy 1101/1121/Rev E/Jun03
V . A S S E M B L Y
SEAT INSTALLATION
The Universal Mounting System (UMS) consists of universal parts that may be used on any medium-back or high-back
seat, regardless of seat width or seat depth. The two main components are aluminum extrusions that can be mounted to
any medium-back or high-back seat. These extrusions attach to a pair of trapeze bars that are mounted to four steel
towers.
WARNING! Do not pick up the seat frame by the armrests. They are free to pivot, and you may lose control
of the seat if they do so, resulting in personal injury or damage to the chair.
To install the seat:
1. Set the seat towers to the desired height. To change the seat height, see VI. “Comfort Adjustments.”
2. Remove the front extrusion clamp from the front extrusion. See figures 7 and 8.
3. Tilt the seat back, and slide the rear extrusion onto the rear trapeze bar.
4. Lower front extrusion onto the front trapeze bar.
5. Place the clamp bracket tab into the extrusion retaining slot and and secure the clamp with the hardware.
6. Plug the controller cable(s) into the connector on the electronics tray. See figure 4.
7. Route the cable to ensure that the cable cannot be pinched in the seat hinge.
8. Secure the controller cable to the armrest receiver with one or more wire ties.
Figure 7. Universal Mounting System Figure 8. Universal Mounting System
(Power Seat)