Pride Mobility JAZZY 1101 - Manual (Page 39)

Jazzy 1101/1121/RevE/Jun03 www.pridemobility.com 39
V I I I . O P E R A T I O N
REMOTE PLUS CONTROLLER
The Remote Plus is a modular electronic control system. The electronics necessary to operate the power chair are con-
tained in several modules located on different parts of your power chair.
The Remote Plus system consists of the following components:
n master remote
n communications cable(s)
n power module
n motor wiring harnesses
n battery wiring harnesses
n actuator lighting module (for optional equipment)
The master remote is located typically on the end of an armrest. The other components are located inside the power base.
Remote Plus Master Remote
The Remote Plus master remote consists of the following
(see figure 23):
1. joystick
2. keypad
3. controller communications cable
4. off-board charger/programming socket
Joystick
The joystick controls the direction and speed of your power
chair. When you move the joystick from the neutral (cen-
ter) position, the electromagnetic brakes release and allow
your power chair to move. The further you push the joy-
stick from its neutral position, the faster your power chair
moves. When you release the joystick and allow it to re-
turn to the neutral position, you engage the electromag-
netic brakes. This causes your power chair to decelerate
and come to a complete stop.
WARNING! If your power chair begins to move in an unexpected manner, immediately release the
joystick. Unless the joystick is damaged, this action should stop your power chair.
Keypad
The keypad is located directly in front of the joystick. See figure 24. It contains keys that you will use to control your power
chair.
On/Off Key
The on/off keys turns the system power on and off.
Figure 23. Remote Plus Master Remote
1
2
3
4