Pride Mobility JAZZY 1101 - Manual (Page 40)

40 www.pridemobility.com Jazzy 1101/1121/Rev E/Jun03
V I I I . O P E R A T I O N
WARNING! Unless faced with an emergency situation, do not use the on/off key to stop the chair.
This will cause the power chair to stop abruptly.
WARNING! Always turn the power off when you are stationary to prevent unexpected movement.
Mode Key
Press the key to change speed setting or to activate the power accessories. See “Speed Settings” or “Power Accessories.”
Speed Setting Indicator
Indicates the selected speed setting.
Power Accessory Indicator
Indicates the selected power accessory. This is for op-
tional accessories only.
Horn Key
The horn key activates the horn.
Right/Left Turn Indicator Keys
The right/left turn indictor keys toggle either the left or
right turn indicators. Press once to turn on and press
again to turn off. You can also turn off the selected indi-
cator by pressing the opposite indicator key or the haz-
ard key.
Light Key
The light key turns headlights/taillights on and off inde-
pendent of other indicators.
Hazard Key
The hazard key toggles both turn indicators at the same
time. You can only cancel this by pressing the hazard
key again.
Battery Condition Meter
The battery condition meter is located in front of the
joystick. This is a 10-segment illuminated display that
indicates that the Remote Plus is turned on and also
gives the status of the battery, the controller, and the
power chair electrical system.
n Red, yellow, and green lights lit: Battery charged; controller and electrical system OK.
n Red and yellow lights lit: Charge battery if possible; controller and electrical system OK.
n Red lights only lit or slow flash: Charge battery as soon as possible; controller and electrical system OK.
n Rapid flash of lights: Indicates a fault in the controller or the electrical system. Refer to “Remote Plus Trouble Codes.”
n Ripple up and down of lights: The joystick was not in the neutral position when the controller was turned on. If you
get “ripple up and down of lights”, turn off the controller, allow the joystick to return to the neutral position, then turn on
the controller.
Figure 24. Remote Plus Keypad