Pride Mobility JAZZY 1101 - Manual (Page 22)

22 www.pridemobility.com Jazzy 1101/1121/Rev E/Jun03
V I . C O M F O R T A D J U S T M E N T S
To adjust the seatback angle:
1. Pull down on the lever.
2. Move the seatback down or up to the desired position.
3. Release the lever.
Seatback Angle Adjustment
If your Jazzy is equipped with an adjustable seatback, you can adjust it
to four (4) different angles: 90°, 102°, 105°, or 107°.
To adjust the seatback angle:
1. Remove the adjusting screws on both seat hinges. See figure 11.
2. Set the seatback at desired angle.
3. Reinstall the screws on both seat hinges and tighten.
Armrest Width Adjustment
You can change each armrest’s width independently of each other.
NOTE: Changing the armrest width may increase the overall
width of your Jazzy.
To change the armrest width:
1. Locate the two armrest knobs on each side of the armrest receiver
bracket. See figure 11.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the knobs.
Armrest Angle Adjustment
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to the floor.
2. Loosen the jam nuts. See figure 11.
3. Loosen the adjusting screw.
4. Turn the adjusting screw clockwise to raise the front of the armrest,
or turn the adjusting screw counterclockwise to lower the front of
the armrest. See figure 11.
5. Tighten the jam nuts to lock the adjusting screw into place.
Footrest Height
The footrest height is easily adjusted to one of six different heights in 1-
in. increments.
To raise or lower the footrest:
1. Remove the nuts and bolts from bracket. See figure 12.
2. Raise or lower the footrest to the desired height.
3. Reinstall the bolts and nuts into the footrest bracket and tighten.
Figure 11. Seatback and Armrest
Adjustments
ADJUSTING
SCREW
ARMREST KNOB
JAM NUT
JAM NUT
Figure 10. Seat Mounting Holes