Pride Mobility JAZZY 1101 - Manual (Page 27)

Jazzy 1101/1121/RevE/Jun03 www.pridemobility.com 27
V I . C O M F O R T A D J U S T M E N T S
Figure 20. Toggle Switch
Power Elevating Seat Operation
You can control the power seat through either the toggle switch located on the armrest or through your controller. For
information on how to raise and lower your power seat through your controller, see VIII. “Operation.”
To operate the power elevating seat:
1. Push the toggle switch forward to raise the seat. See figure 20. When you release the toggle, the seat will stop. Once
the seat reaches its highest extension, the lift action stops; you should continue to hear and/or feel the lift motor running.
This is because there is a clutch mechanism that allows the motor to continue running after the lift has reached its limit.
This clutch works at both the top and bottom extensions of the lift.
WARNING! Do not allow the motor to run more than a few seconds after the mechanism reaches
the top or bottom limit.
2. Pull the toggle switch rearward to return the seat to its lowest position. When returning to the lowest position, always
be sure that the mechanism has reached its lowest limit.
To use the swivel feature:
1. Locate the swivel lever under the seat. It is located on the opposite side of the controller.
2. Push down on the lever to rotate the seat in 90° increments.