Pride Mobility JAZZY 1101 - Manual (Page 33)

Jazzy 1101/1121/RevE/Jun03 www.pridemobility.com 33
V I I I . O P E R A T I O N
On/Off Key
The on/off key turns the VSI on and off.
WARNING! Unless faced with an emergency situation,
do not use the on/off key to stop the power chair.
This will cause the power chair to stop abruptly.
WARNING! Always turn the power off when you are
stationary to prevent unexpected movement.
Battery Condition Meter
The battery condition meter is a 10-segment illuminated display lo-
cated in front of the joystick. It consists of red, yellow, and green
lights. When the lights are on, it indicates that there is power to the
VSI. The lights also indicate battery status, VSI operational status,
and electrical system status.
n Red, yellow, and green lights lit: Battery charged; VSI
operational, and electrical system OK.
n Red and yellow lights lit: Charge battery if possible; VSI
operational, and electrical system OK.
n Red lights only lit or slow flash: Charge battery as soon as
possible; VSI operational, and electrical system OK.
NOTE: When the batteries approach a discharged state, the first
red light will begin to slowly flash, reminding you the batteries
need to be charged immediately!
n Rapid flash of lights: Indicates a fault in the VSI or the electrical system. Refer to “VSI Error Codes.”
n Ripple up and down of lights: The joystick was not in the neutral position when the controller was turned on. If you
get “ripple up and down of lights”, turn off the controller, allow the joystick to return to the neutral position, then turn on
the controller.
NOTE: If you still get “ripple up and down of lights,” contact your authorized Pride Provider.
Speed/Profile Keys
The speed/profile keys control either the speed setting or the drive profile. Press the speed/profile increase key to increase
the speed setting or change the drive profile to a higher number. Press the speed/profile decrease key to decrease the
speed setting or change the drive profile to a lower number. The speed setting or drive profile is displayed on the maxi-
mum speed/profile indicator. If your power chair was programmed with a drive profile, contact your authorized Pride
Provider for more information.
NOTE: We recommend that the first few times you operate your power chair, you use the lowest speed setting until
you become familiar with your new power chair.
Figure 22. VSI Controller Keypad