Pride Mobility JAZZY 1101 User Manual

Page 43

Advertising
background image

Jazzy 1101/1121/RevE/Jun03

www.pridemobility.com

43

V I I I . O P E R A T I O N

Figure 25. Europa Master Remote

1/0

1/0

1

2

3

4

DYNAMIC DX CONTROLLER

The Dynamic DX electronic control system is a modular system. The electronics necessary to operate the power chair are

contained in several modules located on different parts of your power chair.

The Dynamic DX system consists of the following components:

n Europa master remote (see figure 25)

n communications cable(s)

n power module

n motor wiring harnesses

n battery wiring harnesses

n actuator lighting module (for optional systems)

The master remote is located typically on the end of an arm-

rest. The other components are located inside the power base.

Europa Master Remote

The Europa master remote consists of the following:

1. joystick

2. keypad

3. controller communications connector

4. off-board charger/programming socket

Joystick

The joystick controls the direction and speed of the power chair. When you move the joystick from the neutral (center)

position, the electromagnetic brake will release and allow the power chair to move. The further you push the joystick from

its neutral position, the faster your power chair will move. When you release the joystick and allow it to return to the neutral

position, you engage the electromagnetic brake. This helps the power chair decelerate and come to a complete stop.

WARNING! If your power chair begins to move in an unexpected manner, immediately release the

joystick. Unless the joystick is damaged, this action should stop your power chair.

Out Of Neutral At Power Up

Your power chair joystick is equipped with Out Of Neutral At Power Up (OONAPU). If you power up the system and the

joystick is not in the neutral position, the system status light flashes rapidly for either as long as the joystick is out of the

neutral position or for five seconds. If this has happened and the all the lights on the battery condition meter are flashing, you

may have set flash code 1.

Keypad

The keypad is located directly in front of the joystick. It contains keys that you will use to control your power chair.

Advertising
This manual is related to the following products: