Paxar Monarch 917 - Manual (Page 13)

S E T T I N G S U P P L Y O P T I O N S
2
This chapter explains how to select a ribbon, separators, feed
mode, print position, supply position, margin position, cut position,
supply type, speed, backfeed, and verifier options.
You may need to set supply options when you change supplies.
The options are listed in the table below.
Option Choices Default
Ribbon No/Yes/High Energy Yes
Separators No/Yes/Long No
Feed Mode Continuous/On-Demand Continuous
Print Position -99 to +99 0
Supply Position -300 to +300 0
Margin Position -99 to +99 0
Cut Position -300 to +300 0
Supply Type Aperture/Die Cut/Black
Mark/Continuous Die Cut
Speed 2.5/4.0/6.0/8.0/10.0/Default Default
Backfeed Off/On/Extended Off
Verifier Disabled/Enabled Disabled
SUPPLY CONTRAST DEFAULTS
PORT
SETTINGS
RIBBON
MAIN MENU
MARGIN
POS
PRINT
POS
SUPPLY
POS
CANCEL
ALL
PRINT
MODE REPEAT
BATCH
SETUP DIAG.
BATCH
ENTRY
CUT
POSITION
SEPARAT-
ORS
FEED
MODE SUPPLY
TYPE
FORMAT
OPTIONS
SPEED BACKFEED VERIFIER
Setting Supply Options 2-1