Paxar Monarch 917 - Manual (Page 16)

F e e d M o d e
You can use continuous or on-demand printing. On-demand
printing allows you to remove a label before printing the next one.
To change the setting, from the Main Menu, select Setup, then
Supply. Then, follow these steps.
1. Press L or R until you see
SUPPLY
l Feed Mode r
2. Press E to set the supply type option. You will see the
current setting, for example:
SUPPLY TYPE
Continuous r
3. Press L or R to see the other option. After you display the
option you want, press E. Press e twice to exit to the
Main menu.
P r i n t P o s i t i o n
This function adjusts where data prints vertically on the supply.
Adjust the print if it is too close to the top or bottom of the supply,
or overtypes the pre-printed area. One dot is 0.0049 inch.
◆ If the data is too close to the bottom, increase the number.
◆ If the data is too close to the top, decrease the number.
Changing this setting only affects new
formats sent to the printer.
2-4 Setting Supply Options