Paxar Monarch 917 - Manual (Page 21)

S u p p l y Ty p e
You can print on aperture, black mark, die cut, or continuous
supplies. You have to tell the printer which supplies you are
using.
If you are using edge aperture supplies, use
the die cut setting. If you are using center
aperture supplies, use the aperture setting.
To change the setting, from the Main Menu, select Setup, then
Supply. Then, follow these steps.
1. Press L or R until you see
SUPPLY
l Supply Type r
2. Press E to set the supply type option. You will see the
current setting, for example:
SUPPLY TYPE
l Black Mark r
3. Press L or R to see the other options. After you display the
option you want, press E. Press e twice to exit to the
Main menu.
Setting Supply Options 2-9