Panasonic KX-TG5871AL - Manual (Page 46)

Programmable Settings
46
Programming via direct commands
You can also programme features using “direct commands”—special codes that take you
directly to the feature you wish to programme and allow you to select the desired setting.
There is no need to scroll through the unit’s menus.
Details of each feature can be found on the corresponding pages.
Important:
L
Before programming, make sure the handset and base unit are not being used. The
handset must be operated near the base unit and while off the base unit or charger.
1
Press {MENU} (centre of joystick), then press {#}.
2
Enter the desired feature code (shown below).
3
Enter the desired setting code (shown below).
L
This step may vary depending on the feature being programmed.
4
Press {SAVE}.
5
Press {OFF} to exit programming mode.
Note:
L If the handset beeps 3 times, you entered an invalid code. Enter the correct code.
L If you make a mistake or enter the wrong code, press {OFF} then start again by
pressing {MENU}.
Direct commands chart
Important:
L
The default settings are indicated by *.
Feature Feature code Setting code Page
Date and time
{
1} {0} {1} Enter date and time.
(Default: 31.12.2005) 19
Set dial mode
{
1} {2} {0} See page 77. 77
Set recall time
{
1} {2} {1}
{
1}: 700 ms {2}: 600 ms
{ 3}: 400 ms {4}: 300 ms
{
5}: 250 ms {6}: 110 ms
{
7}: 100 ms* {8}: 90 ms
56
Set line mode
{
1} {2} {2}
{
1}: A {2}: B* 57
HS registration
{
1} {3} {0} Go to step 5 on page 59. 59
Deregistration
{
1} {3} {1}
{
3} {3} {5} 58
Enter direct No.
:
TG5871AL.book Page 46 Friday, June 17, 2005 7:01 PM