Powerware 9125 Two-in-One UPS 2500 - Manual (Page 22)

INSTALLATION
EATON Powerware ® 9125 Two-in-One UPS (2500/3000 VA) User’s Guide S 164201374 Rev D
www.powerware.com
16
Connecting the UPS Internal Battery
To ensure proper battery operation before installing the UPS:
1. Verify that the UPS is off and unplugged.
2. Remove the UPS front cover by pulling on both ends (see Figure 2).
Figure 2. Removing the UPS Front Cover
3. Connect the internal battery connector (see Figure 3).
Figure 3. Connecting the Internal Battery Connector
4. Replace the UPS front cover (see Figure 4).
Figure 4. Replacing the UPS Front Cover
5. Continue to the following section, “UPS Setup.”
UPS Setup
The Powerware 9125 UPS is designed for flexible configurations and can
be installed in a rack or as a standalone cabinet.
If you are installing the UPS in a rack, continue to the following section
“Rack-Mount Setup;” otherwise, continue to “Tower Setup” on
page 18.