Powerware 9125 Two-in-One UPS 2500 - Manual (Page 34)

INSTALLATION
EATON Powerware ® 9125 Two-in-One UPS (2500/3000 VA) User’s Guide S 164201374 Rev D
www.powerware.com
28
To hardwire the UPS:
1. If you are installing power management software, connect your
computer to the UPS communication port using the supplied
communication cable.
2. Switch off utility power at the distribution point where the UPS will
be connected. Be absolutely sure there is no power.
Communication Port Terminal Block Cover
UPS
EBM
EBM
Figure 20. Typical Hardwired UPS Installation
3. Remove the terminal block cover and the wiring knockouts (see
Figure 21). Retain the terminal block cover and screws.
Input Wiring Access Output Wiring Access
Terminal Block Cover Screws
Figure 21. Wiring Access and Terminal Block
4. Pull the input and output wires through separate conduit, leaving
approximately 0.5m (2 ft) of exposed wire. Attach a flexible metal
fitting to the end of each conduit.