Tower setup – Powerware 9125 Two-in-One UPS 2500 User Manual
Page 24
INSTALLATION
EATON Powerware
®
9125 Two-in-One UPS (2500/3000 VA) User’s Guide
S 164201374 Rev D
www.powerware.com
18
NOTE The EBMs must be installed below the UPS as shown in Figure 6.
5.
Slide the UPS and any optional EBMs into the rack.
6.
Secure the cabinets to the rack according to the rail kit instructions.
UPS
Optional
EBMs
Figure 6. Rack-Mount UPS with EBMs
7.
If installing optional EBMs, continue to “Extended Battery Module
Installation” on page 22. Otherwise, continue to “Plug-Receptacle
UPS Installation” on page 25 or “Hardwired UPS Installation” on
page 27 to complete the installation.
Tower Setup
The setup varies depending on the number of cabinets you are installing:
1.
For one cabinet, the pedestals must be installed. Continue to Step 2.
For two cabinets, the pedestals and the joining brackets must be
installed. Skip to Step 6.
For three or more cabinets, the joining brackets must be installed. Skip
to Step 9.
2.
Place the UPS cabinet horizontally so that the left end of the cabinet
is accessible (see Figure 7).
3.
Align the pedestals with the screw holes on the end of the UPS
cabinet. Secure the pedestals with the screws provided in the
accessory kit.